LILY* Brushless Motor Controller PWM DC 12V-36V 500W without Hall BLDC Motor Balanced Car Driver Board

Brushless Motor Controller PWM DC 12V-36V 500W without Hall BLDC Motor Balanced Car Driver Board

Features: 100% brand new and high quality

Motor driver board 12-36V DC power input , VCC positive power supply,GND power supply is negative.

Pulse speed signal: high and low output . IC can not understand the information with the customer request

This board has many functions such as stall protection, enable control, over-current protection, steering control and speed control signal.

This driver board has many advantages including low consumption, high reliability and efficiency.

Electrical wiring: three-wire brushless DC motor, corresponding to MA/U, MB/V, MC/W

Tip: If you use a heat sink smaller than 60W and no additional heat sink, you must add a heat sink above 60W. If the driving efficiency of the heat sink is not reduced, excessive temperature will cause sexual damage!

Specification: Operating voltage: DC 12V-36V

Operating Current: <=15A

Driver Power: <=500W

Speed Voltage: 0.1V-5V

Operating Temperature:-40-85C

Humidity: 90%RH

Stall protection:Yes

Enable Control: Yes

Over-current protection: Yes

Steering control: Yes

Speed control signal: Yes

Size: approx 63x42.5x17mm/2.48x1.67x0.67in

Power terminal Out:

VCC(positive power supply)

GND(negative one)

MC(motor phases W)

MB(motor phases V)

MA(motor phase U)

Set for the control side:

GND control terminal ground

VR the governor end 0-5V

ZF reversing control

M tachometer pulse output

EL enable control terminal

Package Includes: 1x 12-36V 500W Brushless Motor Controller

note: Due to the problems of lighting effects and shooting angles, there will be certain tolerances in the product, please understand.

Please allow 0-1cm error due to the manual measurment.

Due to different motor manufacturers to make the hall of hall line order does not necessarily follow the line on the board to match the sequence, need to be adjusted, please parents who pay attention! If the line sequence wrong, does not boot properly, current, or start other phenomena not open, forced to use the drive plate will burn!!!