Fluke Networks LRAT-2000 LinkRunner AT Network Auto-Tester

Fluke Networks LRAT-2000LinkRunner AT Network Auto-Tester User-defined AutoTest performs your required set of connectivity tests in seconds, enabling you to accurately and quickly identify and solve network problems Verify connection at 10/100/1 G over copper or 100/1 G over fiber - connect using copper or fiber, turn it on to see link status, connection type, signal strength and traffic Uses IEEE Link Layer Discovery Protocol (LLDP) plus the Cisco and Extreme Discovery Protocols (CDP and EDP) to display the VLAN and nearest switch model, slot, and port Quickly validate PoE performance by drawing actual power up to the 802.3at standard 25.5W Use before installing cameras, APs, and phones to ensure smooth deployment. Verify access to secure networks using 802.1x and MAC Access Control Lists (ACL) The included LinkRunner Manager software configures 802.1x EAP type, downloads certificates and enters password Check patch cables using the built-in wiremap port including pin-to-pin connection, or installed wiring for length, shorts, opens or split pairs Instead of a ping, which is often blocked or disabled, LinkRunner performs a TCP port open test to verify application connectivity using IPv4 and IPv6. Router, DNS and DHCP servers are reported Designed for field use - six-hour battery life, one-handed operation and a rugged design Easy upgrades - the mini-USB port allows software upgrades in the field in minutes 1 - LinkRunner Manager software CD 1 - USB cable 1 - RJ-45 coupler 1 - Li-ion battery 1 - LinkRunner AT Getting Started Guide 1 - Wireview Cable ID #1 1 - Soft Case